SDD+JLR Mangoose setup instruction and note

Land Rover SDD+JLR Mangoose setup instruction and note

1. JLR J2534 Mongoose 134 readme

Land Rover SDD+Mongoose setup instruction and note:

Step 1: put into CD SDD 134
              Install SDD_DVD134_FULL.exe in the CD
              then install SDD_DVD134.01.exe
              Finally install SDD_DVD134.04.exe

Step 2: After complete setup the first step, put into CD SPA_DVD134
              Install SPA_DVD134_V0.exe
              Finally install VDF_J_DVD134_V5.exe

Step 3: after complete setup the second step, put into CD VDF_L_DVD134
             setup VDF_L_DVD134_V5.exe

Step 4: setup jlr134-license.exe, the password to extract the folder is: jlr134-license-software
              finally setup driver J2534_Mongoose_JLR_x86

Remark: the computer operating system must be Windows XP


2. OBD2 Tool JLR Mangoose ID and Password:

V131
User ID: JLRQ5013
Password: L405X152

V130:
User ID:  JLR9A8172
Password: L538X760

V129:
User ID:  JLR6A9129
Password: L316X351

Please must disconnect internet when you input this user name and password.
The software should install in Disk C://

Know Multi-Di@g Access J2534 and get activation code

Multi-di@g access is software on CD ROM and a VCI (vehicle communication Interface) can be used to communicate with the ecu's according to the J2534 & J2534-1 specifications. Besides ecu reprogramming, with the help of multi-diag access j2534 software, maintenance and repair operations can be done in just a few clicks without being an electronic expert. Equipped with multiply diagnostic functions, pass-thru device (j2534) has a very strong depths of data and is easily handling with that gives big benefits to it's user. In this post I will show you How to get multi-di@g J2534 Pass-Thru OBD2 Device activation code.

J2534 Pass-Thru OBD2 Device software version:
Multi-di@g office I-2010(19.06)

How to get Multi-di@g J2534 Pass-Thru OBD2 Device activation code
If you bought multi-di@g access j2534 interface from China, like http://www.obd365.com/, when you setup the software, it asks you to activate the software, then one note you need to remember is that you should set the VCI serial number as “A070026”, please check the steps as follows:

1. During installation, when Multi-Di@g configuration window appears, you should set Communication interface to USB and set VCI serial number to A070026.

2. 4 days remaining, press the green button.

3. You will see a new window show a code begins with the ID19-…. Please contact us with the code (ID19-...), then we will send you back a password, and you enter it under the “password” form as follow:

4. During the diagnostic with the device connected, warning about 0 days left will appear. Just checkthe mark “Do not display this message again” and continue the work, everything will be ok.

Visit obd365.com technical service website http://www.obd365.com/service/ and get more detail information about the software activation of multi diag access j2534.

http://www.findobd2.com